Garage Door Panel Repair in Fremont
Panel replacement from Navarro Garage Door in Fremont, Newark and Union City starts at $300 for one section, replaced and matched, when the maker still produces it. You hear the exact price at the door before any work starts, and coming out to quote is free. Open 24 hours, seven days a week. Call (510) 443-1883.
From our office at 4510 Peralta Blvd, Centerville
Price
Starting prices
Each price is where that job starts. Your door sets the final number, and you hear it at the door before any work starts.
| Job | Price | What it covers |
|---|---|---|
| Panel replacementOne section, when the maker still produces it | from $300 | One section swapped, when the maker still produces that panel and the color can be matched. On an older door where the panel is no longer made, we say so on the call and price the options. |
Call for your exact price: (510) 443-1883. The visit and the quote are free.
Prices checked October 2026
Licensed, CSLB C-61/D-28
Straightening a dent without a new section is priced on the phone, once we know how deep it goes.
Every price on one pageThe job
Straighten, replace or start again
Straighten the dent
A shallow dent in a steel panel, with no crease and the seams intact, can often be worked back out. The door keeps its strength and the repair stays small.
Replace the section
A creased panel, a split seam or a bent stile means the section has lost its stiffness, and it will keep folding at the same place. One section, replaced and matched, starts at $300 installed.
Replace the door
When two or more sections are damaged, or the panel is no longer made, a new door from $1,500 installed can be the smaller bill. The numbers side by side are on repair or replace.
Matching a panel
A section has to match the rest of the door in maker, model, size, pattern and color. The brand and model are usually on a label on the inside edge of a section. Read them out on the call and we can tell you whether the panel is still made before anyone comes out.
On an older door where the panel is discontinued, the choices are a close match from another maker, two new sections that match each other, or a new door. You get the price for each before deciding.
The bottom panel and moisture
Steel rusts where it stays wet, not where it gets wet. The bottom section sits closest to a damp slab and takes the most water off the driveway, so it is the one that rusts through first. A worn bottom seal speeds that up. If a cable bracket on the bottom section has pulled loose, stop using the door and see the off-track page.
Reviews
What customers say on Google
Questions
Panel questions
Can you replace just one garage door panel?
Yes, when the maker still produces that section in your size and color. One section replaced and matched starts at $300 installed. We need the brand and model, which are usually on a label on the inside edge of the door.
Can a dented garage door panel be fixed without replacing it?
A shallow dent in a steel panel can often be pushed back and the door kept in service. A crease, a split seam or a bent stile can't, because the section has lost its strength. That one needs a new section. A dent repair is priced on the phone once we know which kind it is.
What if my panel is no longer made?
We say so on the call and price the options: a close match from another maker, replacing the damaged section and the one above it so the two match each other, or a new door from $1,500 installed.
Is a dented bottom panel a problem?
It can be. The bottom section carries the bottom brackets, which hold the cables. A dent near a bracket can pull it loose, and a gap under the seal lets water sit against the steel, which is where the rust starts.